To be able to repair your own Mechatronic unit for the DSG6 DQ250 , you will need a few tools.
- A small flat screwdriver
- Screwdriver with T20 bit
- Gloves
- A Dremmel or any small cutting tool with a rotary blade.
- Some masking tape
- Silicone (the one used in cars for the windshield)
- Soldering tools and skills.
- Voltmeter
First thing you will need is PATIENCE and some steady hands :) Also if you do not have any soldering skills or did not tried to solder before , then this is not the DIY for you, and you can stop here.
Find a CLEAN spot on your garage bench or inside your house and prepare to test the DSG Solenoids with a voltmeter as show in the video bellow. If everything is ok on the outside then you can proced to the next steps and CUT the cover of your unit in order to reach the PCB and the wiring inside.
Please watch the video and leave any questions if you have, I will try to answer the best I can.
I have decided to release also Part 2 of DSG DQ250 Mechatronic Repair guide :
3 comments:
Great info this is. I followed these instructions and I was able to replace a solenoid on my unit.upon starting the car when i try to select an option all of them flash that is PDNR. Should I perperf basic settings and adaptation? Thank you. My name is kelvin, golf gti mk5 08 model
Hi, this is a very great and insightful piece. I was ableato follow your instructions and replace a faulty solenoid.Is it mandatory I perform basic setting and adaptation after this ? Thank you.
Yes, when you change a valve you must always perform basic settings.
Post a Comment